Outback HUB 10 -- Brand New and Never Been Tempered Start Price USD 240.00 Current Price USD 240.00 Time Left - Bid Count 0 Buy It Now Price - Reserve Price - Start Time Monday, October 06, 2008 End Time Monday, October 13, 2008 Location Miami, FL See more about 'Outback HUB 10 -- Brand New and Never Been Tempered' Description Outback 10-Port Communication Manager - HUB-10 The OutBack Power Systems HUB-4 and HUB–10 System Communications Manager allows the interconnection of up to ten OutBack power conversion devices with the OutBack MATE. The interconnection creates a completely integrated Power System that is coordinated and managed by the MATE. The OutBack HUB communicates stacking phase, load share, incremental start-up and shut down information directly between the inverters. Interconnection cabling is standard CAT5 eight wire with RJ45 modular jacks. The HUB is powered via any FX inverter/charger or MX60. The OutBack HUB-4 allows the MATE to control any combination of four FX series inverters/chargers and MX60 charge controllers. The OutBack HUB-10 allows the MATE to control up to eight FX series inverters/chargers or up to 10 devices of any combination. HUB-10 Communication Manager The HUB-10 communication manager allows the MATE to control and monitor a maximum of ten OutBack products. The inverter/chargers can be operated in a stacked or independent configuration, and OutBack MX60 PV MPPT charge controllers can also be used on any of the ten available ports of the HUB-10. Future OutBack products will also be compatible with the HUB-10. The HUB-10 manages both the inter-inverter communications and the MATE-inverter communication. The HUB-10 also can be used with the X-240 autotransformer when series stacked to allow full surge and continuous AC load capacity of each FX to be available on either of the 120 VAC output circuits. When two or more FX inverters are stacked in a parallel or series configuration, the system automatically turns off any excess slave inverters to save power and maximize conversion efficiency. This power save system is fully automatic and works with or without the MATE connected to the system One or two MATE system controllers and displays can be connected to the HUB. One Mate is allowed to program the systems while the other MATE is able to only control and display the system operation. When using a single MATE with a HUB-10, programming can be locked out by moving the MATE from the 1st MATE port to the 2nd MATE port once programming has been completed. The maximum distance from the HUB-10 to the power conversion product should be under 10 feet. OutBack includes two 3 foot long and two 6 foot long CAT5 cables standard with the HUB-10. Check with your OutBack dealer for additional cables. Place a Bid!